1kv heat shrink cable terminal kits
Today we talk about 1kv heat shrink cable terminal kits. In fact, we have 1kv, 10kv and 35kv heat shrink cable terminal kits according to the pressure resistance level. These are three kinds, and today we are talking about one kind of 1kv heat shrink cable terminal kits.
1kv heat shrink cable terminal kits can also be called 0.6 / 1kv heat shrink cable terminal kits, which is commonly used in 0.6 / 1kv cable termination processors. Because it is the 1kv heat shrink cable terminal kits, it is not divided into indoor and outdoor on the model. Only for high-pressure cable ternubal kits.
For heat shrink cable terminal kits, it has the characteristics of heating to shrink and be tightly wrapped around the quilt. Because it requires flame device, such as a hot air gun, it is used during construction operations. The staff should be careful. Our suggestion is that it should be operated slowly during the initial construction operation, and then perform normal construction operations after knowing the basic performance of the product, because the basic performance of this product by different manufacturers will be slightly different.
Normally, the correct operation method is to slowly put the heat shrink insulation tube and the finger sleeve onto the smooth, burr-free quilt, that is, the cable. Then bake it slowly, evenly and uniformly, and you must not bake the same part for a long time to avoid product cracking.
The above briefly describes the basic performance of the 1kv heat shrink cable terminal kits and the content that needs attention during operation. Next, we will briefly introduce the applicable square.
The applicable square of 1kv heat shrink cable terminal kits are divided into five types: 0 #, 1 #, 2 #, 3 #, and 4 #, which are respectively expressed as 10-16mm2, 25-50mm2, 70-120mm2, 150-240mm2, 300-400mm2 .
The above is the content of 1kv heat shrink cable terminal kits, which is relatively simple. If you are interested in, please come to communicate and inquiry!